Made in-house
Every Feruga shaft is designed and manufactured in-house in Korea by our parent company, DN Golf Factory. Design, materials, building, finishing and quality control all happen under one roof.
Designed in-house
Our shafts start with our own tapers. Through extensive experimentation we have developed a wide range of tapers for different shaft designs (MTT, Multi Taper Technology). We test each one on experimental mandrels (the forms a shaft is rolled on) with different material combinations before it goes into production.
Chosen materials
We source a wide range of materials from graphite suppliers and keep many types of mandrels. We specifically choose low-resin graphite sheets (LRC) to get the most out of the carbon fiber: strength and stiffness at a similar weight, more stability through the swing and better feedback at impact. A special mix of materials is combined ply by ply to create each shaft (VM, Various Materials).
Built for stability
Triple Torque Technology (TTT) wraps three bias plies in each direction to reduce twist at the tip and butt. It keeps the shaft stable through the downswing and impact, especially on off-center hits, to tighten dispersion and improve control.
Finished by hand
Every Feruga shaft is made one at a time. Before painting, each shaft is hand-sanded more than twice (SSP, Smooth Surface Painting) to give the paint the best possible surface, for better adhesion, durability and appearance.
Strict quality control
If a shaft doesn't meet our strict manufacturing guidelines, it is recycled. No exceptions.